Your Position :
Home » Products » Road Stud Reflectors 100-2

Road Stud Reflectors 100-2

Body Material: ABS
Size: 100*100*20mm (3.94″*3.94″*0.79″)
Filling: Epoxy+Quartz sand
Lens Material: PMMA

Product Introduction

Road Stud Reflectors Features:

 

•Road Stud Reflectors water, oil, chemical, and heat resistance.

•Road Stud Reflectors can work more than 3 years normally.

•Very high reflectivity.

•Road Stud Reflectors easy installation with glues.

•Photometric values:exceeds 600(mcd/lux).

 

Road Stud Reflectors colors
Road Stud Reflectors colors

 

Road Stud Reflectors Parameters:

 

    Body material:      ABS
    Filling:     Epoxy+Quartz Sand
    Lens Material:     PMMA
    Reflector type:     Double side/Single side
    Quality:     ASTM D4280 & EN1463-1 standard
    Size:     100*100*20mm (3.94″*3.94″*0.79″)
    Packing:      56*22.5*22.2cm,100pcs/ctn   (22.05″*8.86″*8.74″,100pcs/ctn)
    Weight:      250g/pc; 25kg/ctn   (0.55bs/pc; 55.12bs/ctn)

 

Plastic Road Stud Reflectors
Plastic Road Stud Reflectors

 

Installation Method Of  Road Stud Reflectors:

1. Determine the installation location and distance, clean the road surface, and ensure that the Road Stud Reflectors are installed on a flat road surface.
2. Clean the bottom of the Road Stud Reflectors and apply the epoxy glue evenly to the back of the studs.
3. Press the side with the glue on the road, fix the position, wait for the glue to dry.
4. Check within 2 hours of installation to ensure that all Road Stud Reflectors are not installed incorrectly and are not bent or deformed due to compression.
5. Remove the installation isolation facility within 6-8 hours after the installation of the Road Stud Reflectors.

Online Message
If you have any question or comment, please contact us without hesitation.
Stay connected
RUICHEN create intelligent solutions that make road safety work.
Inquiry
Copyright © Henan Ruichen Traffic Equipment Co., LTD All Rights Reserved